Link - Right Toe

Fig 1: Toe Link Mounting

Courtesy of CHRYSLER LLC

Slide crossmember end of toe link (1) into box bracket on crossmember. Slide cam bolt (2) through bracket and link from rear of vehicle.
Install bolt (3) and nut securing link to knuckle. Do not tighten bolt at this time.

Fig 2: Rear Toe Adjustment Bolt Nut
Courtesy of CHRYSLER LLC
While holding toe adjustment cam bolt from rotating (cam facing upward), Install cam washer (2) and nut (3) securing toe link at crossmember (1). Do not tighten nut at this time.

Fig 3: WSS Routing Along Left Toe Link
Courtesy of CHRYSLER LLC
If equipped, Attach wheel speed sensor cable (2) to toe link.
Raise rear exhaust back to mounted position and connect exhaust isolators at muffler and resonators hangers. Remove jack or stand below exhaust muffler.

Fig 4: Tire And Wheel Mounting
Courtesy of CHRYSLER LLC
Install tire and wheel assembly (1). Tighten wheel mounting nuts (3) to 150 N.m (110 ft. lbs.) (Police - 190 N.m (140 ft. lbs.)). Refer to INSTALLATION .
Lower vehicle.
Position vehicle on alignment rack/drive-on lift. Raise vehicle as necessary to access mounting bolts.

Fig 5: Toe Link Mounting
Courtesy of CHRYSLER LLC
Tighten toe link (1) fasteners to:
1. Nut at crossmember - 108 N.m (80 ft. lbs.) (This nut may be tightened after rear wheel alignment toe is set. Do not tighten from bolt head end.).
2. Bolt at knuckle - 81 N.m (60 ft. lbs.).
Perform wheel alignment. See STANDARD PROCEDURE .