LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2008 >> Magnum R/T, AWD >> Repair and Diagnosis >> Suspension >> Front Suspension & Rear Suspension (2) >> Rear >> Shock Absorber >> Removal >> Shock Absorber - Standard

Shock Absorber - Standard

  1. Raise and support vehicle. Refer to STANDARD PROCEDURE .
    Fig 1: Tire And Wheel Mounting
    GC0012971Courtesy of CHRYSLER LLC
  2. Remove wheel mounting nuts (3), then tire and wheel assembly (1).
  3. Position under-hoist utility jack or jack stand under outer spring link adding just enough support to keep suspension from going into full-rebound when shock absorber mounting bolts are removed.
    Fig 2: Lower Shock Mount
    GC0012978Courtesy of CHRYSLER LLC
  4. Remove shock absorber (1) lower mounting bolt (2) and nut (4).
    Fig 3: Shock And Frame Mounting - Upper
    GC0014106Courtesy of CHRYSLER LLC
  5. Remove shock absorber (1) upper mounting bolts (2).
  6. Remove shock absorber (4).
scientia non olet · About LEMON Manuals