LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2008 >> Magnum R/T, AWD >> Repair and Diagnosis >> Suspension >> Front Suspension & Rear Suspension (2) >> Rear >> Link-Compression >> Installation >> Link - Compression

Link - Compression

NOTE: Although the compression link is different end-to-end, there is no top and bottom.
Fig 1: Compression Link Mounting
GC0012997Courtesy of CHRYSLER LLC
  1. Position link and install bolt and nut (1) mounting link (3) at crossmember. Do not tighten bolt at this time. 
  2. Install bolt and nut (2) mounting link (3) at knuckle. Do not tighten bolt at this time. 
    Fig 2: Tire And Wheel Mounting
    GC0012971Courtesy of CHRYSLER LLC
  3. Install tire and wheel assembly (1). Tighten wheel mounting nuts (3) to 150 N.m (110 ft. lbs.) (Police - 190 N.m (140 ft. lbs.)). Refer to INSTALLATION .
  4. Lower vehicle.
  5. Position vehicle on alignment rack/drive-on lift. Raise vehicle as necessary to access link fasteners.
  6. Tighten compression link fasteners to:
    1. Bolt at crossmember - 85 N.m (63 ft. lbs.).
    2. Bolt at knuckle - 81 N.m (60 ft. lbs.).
  7. Perform wheel alignment. See STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals