LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2008 >> Charger SXT, AWD >> Repair and Diagnosis >> Suspension >> Front Suspension & Rear Suspension (2) >> Front >> Hub And Bearing >> Removal >> Hub And Bearing - RWD

Hub And Bearing - RWD

  1. Raise and support vehicle. Refer to STANDARD PROCEDURE .
    Fig 1: Tire And Wheel Mounting
    GC0012971Courtesy of CHRYSLER LLC
  2. Remove wheel mounting nuts (3), then tire and wheel assembly (1).
  3. Access and remove front brake rotor. Refer to REMOVAL .
    Fig 2: Dust Cap & Hub Nut
    GC0014042Courtesy of CHRYSLER LLC
  4. Remove dust cap (2). When doing this, avoid damaging internal bore of hub to preserve seal integrity.
  5. Remove hub nut (1).
  6. Slide hub and bearing off knuckle spindle.
scientia non olet · About LEMON Manuals