Brake Shoes &/Or Pads: Remove & Replace
WARNING: This page is about the Nitro SLT, AWD, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Both Axles | 1.8 | B | ||
| Front Axle | 1.0 | B | ||
| Rear Axle | 1.0 | B | ||
| Combination Procedure: AXLE SEAL: Replace: | ||||
| Both,Rear | 1.3 | B | ||
| One Side,Rear | 1.0 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: | ||||
| Each Additional | 0.2 | B | ||
| One | 0.3 | B | ||
| Combination Procedure: CALIPER: Replace: | ||||
| One | 0.3 | B | ||
| Combination Procedure: DISC ROTOR: Replace: | ||||
| 0.1 | B | |||
| Combination Procedure: PARKING BRAKE SHOE & LINING: Replace: | ||||
| Both Sides | 1.0 | B | ||
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| Front,One | Serviced with Wheel Hub Assembly. | B | ||
| Rear,One Side | Refer to Rear Wheel Bearing - R&R. | B | ||