LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Viper >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel >> Cluster Bezel >> Removal

Cluster Bezel: Removal

WARNING: Follow all Warnings for airbag component service (Refer to RESTRAINTS ).
  1. Open deck lid.
  2. Remove four bolts to battery compartment cover and remove cover.
  3. Disconnect and isolate the battery negative cable.
  4. Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or instrument panel component service.
  5. Remove the center bezel. (Refer to INSTRUMENT PANEL CENTER BEZEL  ).
  6. Remove eight screws and slide the tunnel console back to get enough room to remove the bezel. (Refer to - FRONT TUNNEL CONSOLE - REMOVAL ).
  7. Remove the steering column cover. (Refer to INSTRUMENT PANEL STEERING COLUMN COVER  ).
  8. Using a trim stick C-4755 or equivalent, remove the left speaker cover.
  9. Remove the three screws along the bottom edge of the bezel next to the steering column.
  10. Using a trim stick C-4755 or equivalent, gently pry out on cluster bezel.
scientia non olet · About LEMON Manuals