Fluid Reservoir: Removal
NOTE:
The master cylinder does not need to be removed from the power brake booster for removal and installation of the fluid reservoir.
- Clean the master cylinder housing and brake fluid reservoir exterior surfaces. See Fig 1.
- Remove the brake fluid reservoir cap. Using a clean syringe or siphoning tool, empty as much brake fluid as possible from the reservoir.
- Remove the vehicle wiring harness connector from brake fluid level switch in master cylinder brake fluid reservoir.
- Remove the 2 plastic pins holding the reservoir to the master cylinder.
- Lift the reservoir from the master cylinder casting.
- Remove the grommets (O-ring) sealing the reservoir to the master cylinder housing.