Headlamp Leveling Switch - Export: Removal
- Rotate the A/C outlet registers to the full down position. Grip each outlet at its outboard end and gently over-rotate to release from its pivot point. Swing outlet straight out and remove by hand.
- Remove the (4) HVAC control knobs by pulling straight off the switch shaft.
- Remove the (2) screws from the center instrument bezel.
- Remove the center instrument bezel. Pull it straight out to unsnap the (4) retaining clips.
- Remove the (2) screws from the accessory switch bank.
- Pull the accessory switch bank out and disconnect the electrical connector from the headlamp leveling switch.
- Gently pry the headlamp leveling switch out of its mounting clips (Fig 1).
Courtesy of DAIMLERCHRYSLER CORP.