Diagnosis And Testing - Front Position Lamps- Export
The following test is designed to diagnosis a faulty front position lamp. Refer to appropriate Wiring Diagrams for a complete system schematic.
NOTE:
Battery must be completely charged (12v) prior to testing. It may also be necessary to install battery charger on the vehicles electrical system when performing this test. Refer to the BATTERY SYSTEM
article for detailed information.
- Remove the front position lamp bulb and check for burned out condition, replace bulb if necessary.
- If bulb appears OK, reinstall the bulb in its socket and rotate the left side multi-function switch one detent position and check for lamp operation. If lamp is still inoperative proceed to step 3.
- Remove lamp bulb and check for proper power (12v) and ground connections in lamp socket. If power and/or ground connections are not present, trace wire until open or short is found. Refer to appropriate Wiring Diagrams for a complete system schematic.