LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Front Suspension - 4WD Torsion Bar) >> Removal & Installation >> Torsion Bars >> Removal

Torsion Bars: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support vehicle with suspension hanging. Unload torsion bar completely by turning adjusting bolt counterclockwise. Count number of turns to aid installation. See Fig 1.
    Fig 1: Removing Torsion Bar
    G94B65566Courtesy of CHRYSLER CORP.
  2. Remove adjustment bolt from swivel. Remove torsion bar and anchor as an assembly. Separate torsion bar from anchor.
  3. Remove all foreign material from torsion bar mounting in anchor and control arm. Inspect torsion bars, anchors, swivels, bushings and crossmember support for bends, cracks, deterioration and damage. Check adjustment bolt and nut for damage and stripped threads. Replace components as necessary.
scientia non olet · About LEMON Manuals