LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Front Suspension - 4WD Torsion Bar) >> Removal & Installation >> Hub & Bearing Assembly >> Installation

Hub & Bearing Assembly: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install hub and bearing assembly onto steering knuckle, guiding CV axle shaft through spline in hub. Tighten hub and bearing assembly-to-steering knuckle mounting bolts to specification. See TORQUE SPECIFICATIONS . Install brake rotor and caliper.
  2. Install ABS wheel speed sensor, if equipped. Install hub nut and washer, and tighten to specification. Install wheel and tire assembly. Remove support and lower vehicle
scientia non olet · About LEMON Manuals