LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Air Conditioning Controls) >> Mode Door Actuator >> Installation

Mode Door Actuator: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the mode door actuator onto the HVAC distribution housing. If necessary, rotate the actuator slightly to align the splines on the actuator output shaft with those in the mode cam.
  2. Install the two screws that secure the mode door actuator to the distribution housing. Tighten the screws to 2 N.m (17 in. lbs.).
  3. Connect the wire harness connector to the mode door actuator.
  4. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals