LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Air Conditioning Controls) >> Blower Motor Resistor Block >> Installation

Blower Motor Resistor Block: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the blower motor resistor block into the HVAC housing.
  2. Install the two screws that secure the blower motor resistor block to the HVAC housing. Tighten the screws to 2.2 N.m (20 in. lbs.).
  3. Connect the wire harness connector to the blower motor resistor block.
  4. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals