LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Air Conditioning Controls) >> Blend Door Actuator >> Installation

Blend Door Actuator: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the blend door actuator onto the HVAC housing. If necessary, rotate the actuator slightly to align the splines on the actuator output sleeve with those on the blend door linkage.
  2. Install the screws that secure the blend door actuator to the HVAC housing. Tighten the screws to 2 N.m (17 in. lbs.).
  3. Connect the HVAC wire harness connector to the blend door actuator.
  4. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals