LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Air Conditioning Controls) >> A/C Pressure Transducer >> Removal

A/C Pressure Transducer: Removal

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: It is not necessary to discharge the refrigerant system to replace the A/C pressure transducer.
  1. Disconnect and isolate the negative battery cable.
  2. Disconnect the wire harness connector from the A/C pressure transducer.
  3. Remove the A/C pressure transducer from the fitting on the liquid line ( Figure ).
  4. Remove the O-ring seal from the A/C pressure transducer fitting and discard.
scientia non olet · About LEMON Manuals