LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Air Conditioning Controls) >> A/C Pressure Transducer >> Installation

A/C Pressure Transducer: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Replace the O-ring seal before installing the A/C pressure transducer.
  1. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it on the A/C pressure transducer fitting. Use only the specified O-rings as they are made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
  2. Install the A/C pressure transducer onto the liquid line fitting. The transducer should be hand-tightened securely.
  3. Connect the wire harness connector to the A/C pressure transducer.
    Fig 1: Identifying A/C Pressure Transducer Components
    G03489454Courtesy of DAIMLERCHRYSLER CORP.
  4. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals