Overdrive Switch: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: There is enough slack in the wire to pull out the connector from the lever.

Pull the connector out of the lever just enough to grasp it.
CAUTION: Be careful not to bend the pins on the overdrive off switch. Use care when installing the switch, as it is not indexed, and can be accidentally installed incorrectly.
Install the overdrive off switch into the connector ( Fig 1)

Fig 1: Installing Overdrive Off Switch
Courtesy of DAIMLERCHRYSLER CORP.
Push the overdrive off switch and wiring into the shift lever.
Install the overdrive off switch retainer onto the shift lever.