LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Overhaul - 42RLE Automatic Transmission) >> Output Speed Sensor >> Installation

Output Speed Sensor: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the output speed sensor into the transmission case.
    NOTE: Before installing the speed sensor bolt, it will be necessary to replenish the sealing patch on the bolt using Mopar® Lock & Seal Adhesive.
  2. Install the bolt to hold the output speed sensor into the transmission case. Tighten the bolt to 9 N.m (80 in. lbs.).
  3. Install the wiring connector onto the output speed sensor
  4. Verify the transmission fluid level. Add fluid as necessary.
  5. Lower vehicle.
scientia non olet · About LEMON Manuals