LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Overhaul - 42RLE Automatic Transmission) >> Input Speed Sensor >> Removal

Input Speed Sensor: Removal

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise vehicle.
  2. Place a suitable fluid catch pan under the transmission.
  3. Remove the wiring connector from the input speed sensor ( Fig 1).
    NOTE: The speed sensor bolt has a sealing patch applied from the factory. Be sure to reuse the same bolt.
  4. Remove the bolt holding the input speed sensor to the transmission case.
  5. Remove the input speed sensor from the transmission case.
    Fig 1: Locating Input Speed Sensor
    G03489302Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals