TEST TWO A-SELECTOR IN OD (Fourth Gear)
WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This test checks the underdrive clutch hydraulic circuit as well as the shift schedule.
- Attach gauge to the underdrive clutch tap.
- Move selector lever to the OD position.
- Allow wheels to rotate freely and increase throttle opening to achieve an indicated speed of 40 mph.
- Underdrive clutch pressure should read below 5 psi. If not, than either the solenoid assembly or controller is at fault.