LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Steering Column Switches) >> Tilt Lever Knob Release >> Removal

Tilt Lever Knob Release: Removal

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the tilt lever handle.
  2. Remove the lower shroud.
    NOTE: Use special care not to pry on the clock-spring electrical connector when removing or installing the mounting screw located next to the clockspring.
  3. Remove the two mounting screws from the tilt lever knob release bracket ( Fig 1 ).
  4. Disconnect the electrical harness plastic mounting tab from the bracket ( Fig 1 ).
    Fig 1: Removing Tilt Lever Knob Release Bracket
    G03489002Courtesy of DAIMLERCHRYSLER CORP.
  5. Unsnap the cable from the bracket ( Fig 2 ).
    Fig 2: Removing Cable Unsnapped
    G03489003Courtesy of DAIMLERCHRYSLER CORP.
  6. Remove the end of the cable from the tilt lever knob release bracket ( Fig 3 ).
    Fig 3: Removing End Of Cable To Tilt Lever Release Knob
    G03489004Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals