LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Steering Column Switches) >> Tilt Lever Knob Release >> Installation

Tilt Lever Knob Release: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Route the cable into the tilt lever release knob bracket ( Figure ).
  2. Snap the cable end into the bracket ( Figure ).
    NOTE: Use special care not to pry on the clock-spring electrical connector when removing or installing the mounting screw located next to the clockspring.
    NOTE: New screws should be used when installing the tilt lever release knob bracket to the column.
  3. Install the tilt lever release knob bracket to the column and install the two new mounting screws ( Figure ) Tighten the two new screws to 4.5 N.m (40 in. lbs.).
  4. Install the electrical harness plastic mounting tab to the bracket ( Figure ).
  5. Install the lower shroud.
  6. Install the tilt lever handle.
scientia non olet · About LEMON Manuals