LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (3.7L Engine (Service Information)) >> Rear Mount >> Installation

Rear Mount: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Threadlocking compound must be applied to the bolts before installation.
  1. Install the two bolts that attach the transmission mount to the transmission bracket.
  2. Torque the bolts to 61N.m (45 ft.lbs.) torque.
  3. Lower the transmission so the transmission mount rests on the crossmember, and the studs of the transmission mount are aligned in the slots in the crossmember.
  4. Install the nuts onto the transmission mount studs through the crossmember access slot.
  5. Torque the nuts to 54N.m (40 ft. lbs.).
scientia non olet · About LEMON Manuals