LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (3.7L Engine (Service Information)) >> Front Mount >> Installation >> 2WD

Front Mount: Installation: 2WD

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For mount to engine block and left engine bracket to front axle bolts, apply Mopar(R) Lock and Seal Adhesive, Medium Strength Threadlocker.
  1. Install the right and left side engine mounts to the engine block with (8) bolts. Torque bolts to 54 N.m (40 ft. lbs.).
  2. Insert the (2) through bolts into the right and left side engine mounts and loose assemble the two nuts onto the through bolts.
  3. Lower the engine until the through bolts rest onto the slots in the frame brackets.
  4. Tighten the through bolt nuts to 94 N.m (70 ft. lbs.).
  5. Install the oil drain trough.
  6. Install the engine oil filter.
  7. Lower the vehicle.
  8. Install the viscous fan (Refer to RADIATOR FAN - VISCOUS ).
  9. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals