LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Speed Control) >> Cable >> Removal >> Removal - 4.7L

Removal - 4.7L

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable at battery.
  2. Remove air box housing from throttle body.

    The accelerator cable must be partially removed to gain access to speed control cable.

  3. Using finger pressure only, disconnect accelerator cable connector at throttle body bellcrank pin by pushing connector off bellcrank pin towards front of vehicle ( Fig 1 ). DO NOT try to pull connector off perpendicular to the bellcrank pin. Connector will be broken. 
  4. Lift accelerator cable from top of cable cam ( Fig 1 ).
  5. Press tab ( Fig 2 ) to release plastic cable mount from bracket. Press on tab only enough to release cable from bracket. If tab is pressed too much, it will be broken.  Slide plastic mount ( Fig 2 ) towards passenger side of vehicle to remove cable from bracket.
  6. Using finger pressure only, disconnect speed control cable connector at throttle, body bellcrank pin by pushing connector off bellcrank pin towards front of vehicle ( Fig 1 ). DO NOT try to pull connector off perpendicular to the bellcrank pin. Connector will be broken. 
    Fig 1: Identifying Cable Connectors At Bell Crank - 4.7L
    G03488573Courtesy of DAIMLERCHRYSLER CORP.
    Fig 2: Identifying Accelerator Cable Release Tab - 4.7L
    G03488574Courtesy of DAIMLERCHRYSLER CORP.
  7. Slide speed control cable plastic mount towards passenger side of vehicle to remove cable from bracket ( Fig 3 ).
  8. Remove servo cable from servo. Refer to SERVO  .
    Fig 3: Identifying Speed Control Cable At Bracket - 4.7L
    G03488575Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals