LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Lamps & Lighting - Interior) >> 2ND Seat Dome/Reading Lamp >> Installation

2ND Seat Dome/Reading Lamp: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the dome/reading lamp to the mounting hole in the headliner.
  2. Reconnect the body wire harness connector for the lamp to the lamp connector receptacle.
  3. Insert the fixed retainer on the notched end of the lamp housing up into one side of the mounting hole in the headliner ( Figure ).
  4. Slide the notched end of the lamp housing into the mounting hole far enough to engage the lens hinge/retainer into the opposite side of the mounting hole in the headliner.
  5. Gently press the lens hinge/retainer end of the lamp upward into the mounting hole until the bezel of the lamp housing is flush with the headliner.
  6. Swing the notched end of the lamp lens up into position against the lamp housing, then press upward on the lens firmly and evenly until it snaps into the housing.
  7. Reconnect the battery negative cable.
scientia non olet · About LEMON Manuals