2ND Seat Dome/Reading Lamp Bulb: Removal
WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the battery negative cable.
- Insert the tip of a small flat bladed screwdriver into the notch between the lamp lens and the lamp housing on one side of the dome/reading lamp.
- Gently pry the notched edge of the dome/reading lamp lens downward until it unsnaps from the lamp housing.
- Swing the notched edge of the lamp lens downward far enough to access the lamp bulb ( Figure ).
- Remove the lamp bulb from the bulb holders within the lamp housing.