Hard Wired Inputs
WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
The hard wired inputs to the EMIC include the following:
- Fused B(+) - Ignition-Off Draw
- Fused Ignition Switch Output (Run-Start) - (2 Circuits)
- Headlamp Switch Output
- High Beam Indicator Driver
- Left Turn Signal
- Panel Lamps Driver
- Right Turn Signal
- Seat Belt Indicator Driver
- Transmission Range Sensor MUX - with Auto Trans
- VTSS Indicator Driver - with Vehicle Theft Security System
- Washer Fluid Switch Sense
Refer to SYSTEM WIRING DIAGRAMS for additional details.