Check Gauges Indicator: Operation

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.

The check gauges indicator gives an indication to the vehicle operator when certain instrument cluster gauge readings reflect a condition requiring immediate attention. This indicator is controlled by a transistor on the instrument cluster circuit board based upon cluster programming and electronic messages received by the cluster from the Powertrain Control Module (PCM) over the Programmable Communications Interface (PCI) data bus. The check gauges indicator Light Emitting Diode (LED) is completely controlled by the instrument cluster logic circuit, and that logic will only allow this indicator to operate when the instrument cluster receives a battery current input on the fused ignition switch output (run-start) circuit. Therefore, the LED will always be off when the ignition switch is in any position except On or Start. The LED only illuminates when it is provided a path to ground by the instrument cluster transistor. The instrument cluster will turn on the check gauges indicator for the following reasons:

Bulb Test - Each time the ignition switch is turned to the On position the check gauges indicator is illuminated for about two seconds as a bulb test.
Engine Temperature High Message - Each time the cluster receives a message from the PCM indicating the engine coolant temperature is about 122° C (252° F) or higher, the check gauges indicator will be illuminated. The, indicator remains illuminated until the cluster receives a message from the PCM indicating that the engine coolant temperature is below about 119° C (246° F), or until the ignition switch is turned to the Off position, whichever occurs first.
Engine Oil Pressure Low Message - Each time the cluster receives a:; message from the PCM indicating the engine oil pressure is about 6.9 kPa (1 psi) or lower, the check gauges indicator will be illuminated. The indicator remains illuminated until the cluster receives a message from the PCM indicating that the engine oil pressure is above about 6.9 kPa (1 psi), or until the ignition switch is turned to the Off position, whichever occurs first. The cluster will only turn the indicator on in response to an engine oil pressure low message if the engine speed is greater than zero.
System Voltage Low (Charge Fail) Message - Each time the cluster receives, a message from the PCM indicating the electrical system voltage is less than about 11.5 volts charge fail condition), the check gauges indicator will be illuminated. The indicator remains illuminated until the cluster receives a message from the PCM indicating the electrical system voltage is greater than about; 12.0 volts (but less than 16.0 volts), or until the ignition switch is turned to the Off position, whichever occurs first.
System Voltage High Message - Each time the cluster receives a message from the PCM indicating the electrical system voltage is greater than about 16.0 volts, the check gauges indicator will be illuminated. The indicator remains illuminated until the cluster receives a message from the PCM indicating the electrical system voltage is less than about 15.5 volts (but greater than 11.5 volts), or until the ignition switch is turned to the Off position, whichever occurs first.
Actuator Test - Each time the cluster is put through the actuator test, the check gauges indicator will be turned on, then off again during the bulb check portion of the test to confirm the functionality of the LED and the cluster control circuitry.

The PCM continually monitors the engine temperature, oil pressure, and electrical system voltage, then sends the proper messages to the instrument cluster. For further diagnosis of the check gauges indicator or the instrument cluster circuitry that controls the LED, (Refer to DIAGNOSIS AND TESTING - INSTRUMENT CLUSTER ). For proper diagnosis of the PCM, the PCI data bus, or the electronic message inputs to the instrument cloister that control the check gauges indicator, a DRBIII(R) scan tool is required. Refer to ELECTRONIC CONTROL MODULES .