LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 81 (Automatic Transmission Cooler) >> Transmission Cooler >> Installation - Oil To Air Transmission Cooler

Installation - Oil To Air Transmission Cooler

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the transmission cooler tubes to the front of the radiator.
  2. Snap the transmission cooler tubes into the clips on the side of the radiator tank.
  3. Install the transmission cooler attaching bolts. Tighten the bolts to 16 N.m (140 in. lbs.).
  4. Inspect the quick connect fittings for debris and install the quick connect fitting on the cooler tube until an audible "click" is heard. Pull apart the connection to verify proper installation and install the secondary latches.
  5. Connect the battery negative cable.
  6. Start the engine and check all fittings for leaks.
  7. Check the fluid level in the automatic transmission. Refer to the appropriate TRANSMISSION article.
scientia non olet · About LEMON Manuals