LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Engine Cooling System) >> Water Pump Inlet Tube >> Installation >> With Air Conditioning

With Air Conditioning

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position bypass hose clamps to center of hose.
  2. Install bypass hose to engine.
  3. Secure both hose clamps ( Figure).
  4. Install generator-A/C mounting bracket assembly to engine. Tighten bolts (number 1 and 2 - ( Figure) to 54 N.m (40 ft. lbs.) torque. Tighten bolts (number 3- ( Figure)to 40 N.m (30 ft. lbs.) torque.
  5. Install a new O-ring to the heater hose coolant return tube ( Figure). Coat the new O-ring with antifreeze before installation.
  6. Install coolant return tube and its mounting bolt to engine ( Figure).
  7. Connect throttle body control cables.
  8. Install oil dipstick mounting bolt.
  9. Install idler pulley. Tighten bolt to 54 N.m (40 ft. lbs.) torque.
  10. Install drive belt (Refer to ACCESSORY DRIVE ).
  11. Install air cleaner assembly.
  12. Install upper radiator hose to radiator.
  13. Connect wiring harness to A/C compressor.
  14. Connect battery negative cable.
  15. Fill cooling system (Refer to STANDARD PROCEDURE - REFILLING COOLING SYSTEM ).
  16. Start and warm the engine. Check for leaks.
scientia non olet · About LEMON Manuals