LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (HVAC - Airflow Distribution) >> HVAC Housing >> Removal >> Removal- HVAC Housing Plenum Adapter

Removal- HVAC Housing Plenum Adapter

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
  1. Remove the heater-A/C housing from the vehicle (Refer to REMOVAL- HVAC HOUSING  ).
  2. Slide the heater-A/C housing plenum adapter all the way to one side of the plenum opening.
  3. Pull downwards sharply and firmly on the opposite side of the plenum adapter to disengage the snap feature from the plenum opening.
  4. Remove the plenum adapter from the plenum panel.
scientia non olet · About LEMON Manuals