Blower Motor: Operation
The blower motor will only operate when the ignition switch is in the On position, and the heater-A/C blower control switch knob is in any position, except Off. The blower motor receives a fused battery feed through the blower motor relay whenever the ignition switch is in the On position.
The blower motor battery feed circuit is protected by a fuse in the Power Distribution Center (PDC). The blower motor control circuit is protected by a fuse in the junction block. Blower motor speed is controlled by regulating the ground path through the heater-A/C mode control switch, the blower motor switch, the blower motor resistor.
The blower motor and blower motor wheel cannot be repaired and, if faulty or damaged, they must be replaced. The blower motor and blower wheel are each serviced separately.