LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Air Conditioning Controls) >> Blower Motor Resistor Block >> Installation

Blower Motor Resistor Block: Installation

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Plug the blower motor resistor into the wire harness connector.
  2. Install the blower motor resistor to the cowl plenum panel by feeding the resistor and wire harness back through the cowl plenum access hole.
  3. Install and tighten the two screws that secure the resistor to the HVAC unit. Tighten the screws to 2.2 N.m (20 in. lbs.).
  4. Connect the battery negative cable.
scientia non olet · About LEMON Manuals