LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Air Conditioning Controls) >> A/C Pressure Transducer >> Installation

A/C Pressure Transducer: Installation

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate a new O-ring seal with clean refrigerant oil and install it on the discharge line fitting. Use only the specified O-rings as they are made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the compressor in the vehicle.
  2. Install and tighten the A/C pressure transducer on the discharge line fitting.
  3. Plug the wire harness connector into the A/C pressure transducer.
  4. Connect the battery negative cable.
scientia non olet · About LEMON Manuals