LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Air Conditioning Controls) >> A/C Pressure Transducer >> Diagnosis And Testing - A/C Pressure Transducer

Diagnosis And Testing - A/C Pressure Transducer

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.

Before performing diagnosis of the a/c pressure transducer switch, verify that the refrigerant system has the correct refrigerant charge. (Refer to DIAGNOSIS AND TESTING )

  1. Turn on engine and have a/c selected.
  2. Using the DRB-III monitor and record the pressure value as it is sent out from the PCM.
  3. Connect the high side manifold gauge set to the fitting on the liquid line high side refrigerant system service port.
  4. Compare the DRB-III pressure value to the manifold gauge set reading. The pressure reading from the DRB-III should similar to the reading of the manifold gauge set value.
  5. If not, replace the a/c pressure transducer.
scientia non olet · About LEMON Manuals