Section 69 (Stationary Glass): BACKLITE: Removal
WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
(Refer to
BODY/STATIONARY GLASS/WINDSHIELD-WARNING
) for applicable glass removal safety precautions.
- On standard cab models, remove the B-pillar trim. (Refer to B-PILLAR TRIM )
- Remove the c-pillar trim, if equipped. (Refer to C-PILLAR TRIM )
- Remove the quarter trim, if equipped. (Refer to QUARTER TRIM PANEL )
- Remove cab back panel trim. (Refer to REAR CAB BACK PANEL TRIM )
- Bend backlite retaining tabs (Figure ) inward against glass.
- Using a long knife from inside the vehicle, cut urethane holding backlite frame to opening fence.
- Separate glass from vehicle.