LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Seats) >> Seat-Front Bucket >> Installation

Seat-Front Bucket: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position seat in vehicle.
    NOTE: Ensure each seat track is equally positioned in the full rearward position.
  2. Install bolts attaching front seat track to floor pan and tighten to 28 N.m (20 ft. lbs.).
  3. Install front screws attaching trim cover to seat track.
  4. Move seat to full forward position.
  5. Install bolts attaching rear inboard seat track and rear outboard seat track to floor pan and tighten to 46 N.m (34 ft. lbs.).
  6. Install rear screws attaching trim cover to seat track.
  7. If equipped, engage power seat switch connector and install side shield.
scientia non olet · About LEMON Manuals