Floor Shift Boot: Removal
WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
- Using a trim stick C-4755 or equivalent, pry out insert from shift knob (Figure ).
- Remove nut attaching shift knob to gear shift.
- Pull knob off gear shift.
- Using a small flat bladed screwdriver pry up one corner of the bezel/boot assembly. Do not separate the boot from the bezel.
- Lift the boot/bezel assembly off of the floor panel and over the gear shift (Figure ) and (Figure ).