LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Instrument Panel) >> Base Trim >> Installation

Base Trim: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, SEAT BELT TENSIONER, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
  1. Position the base trim onto the instrument panel structural support.
  2. Install and tighten the screws around the perimeter of the instrument panel that secure the base trim to the instrument panel structural support.
  3. Install the top cover onto the instrument panel. (Refer to BODY/INSTRUMENT PANEL/TOP COVER-INSTALLATION  ).
  4. Install the radio into the instrument panel. (Refer to INSTALLATION ).
  5. Install the instrument cluster into the instrument panel. (Refer to INSTALLATION ).
  6. Install the instrument panel into the vehicle. (Refer to BODY/INSTRUMENT PANEL-INSTALLATION  ).
  7. Connect the battery negative cable.
scientia non olet · About LEMON Manuals