LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Exterior) >> Roof Joint Molding >> Installation

Roof Joint Molding: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove adhesive tape residue from roof joint.
  2. If molding is to be reused, remove tape residue from back of molding. Clean molding with Mopar(R), Super Kleen solvent or equivalent. Wipe molding dry with lint free cloth. Apply new body side molding (two sided adhesive) tape to back of molding.
  3. Clean roof joint with Mopar(R), Super Kleen solvent or equivalent. Wipe dry with lint free cloth.
  4. Remove protective cover from tape on back of molding and apply molding to roof joint.
  5. Heat roof and molding, see step one. Firmly press molding into roof joint to assure adhesion.
scientia non olet · About LEMON Manuals