LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Exterior) >> Exterior Name Plates >> Removal

Exterior Name Plates: Removal

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Exterior nameplates are attached to body panels with adhesive tape.
  1. Apply a length of masking tape on the body, parallel to the top edge of the nameplate to use as a guide, if necessary.
  2. If temperature is below 21°C (70°F) warm emblem with a heat lamp or gun. Do not exceed 52°C (120°F) when heating emblem.
  3. Insert a plastic trim stick or a hard wood wedge behind the emblem to separate the adhesive backing from the body.
  4. Clean adhesive residue from body with Mopar(R) Super Clean solvent or equivalent.
scientia non olet · About LEMON Manuals