LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Exterior) >> Exterior Name Plates >> Installation

Exterior Name Plates: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove carrier from back of emblem.
  2. Position emblem properly on body (Figure ).
  3. Press emblem firmly to body with palm of hand.
  4. If temperature is below 21°C (70°F) warm emblem with a heat lamp or gun to assure adhesion. Do not exceed 52°C (120°F) when heating emblem.
scientia non olet · About LEMON Manuals