LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Exterior) >> Body Side Moldings >> Removal

Body Side Moldings: Removal

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply a length of masking tape on the body, parallel to the top edge of the molding to use as a guide, if necessary.
  2. Warm the effected stick-on molding and body metal to approximately 38°C (100°F) using a suitable heat lamp or heat gun.
  3. Pull stick-on molding from painted surface (Figure ).
scientia non olet · About LEMON Manuals