LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Exterior) >> Body Side Moldings >> Installation

Body Side Moldings: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean body surface with Mopar(R) Super Kleen solvent or equivalent. Wipe surface dry with lint free cloth.
  2. Remove protective cover from tape on back of molding. Apply molding to body below the masking tape guide.
  3. Remove masking tape guide and heat body and molding. Firmly press molding to body surface to assure adhesion (Fig 1 ).
    Fig 1: Removing/Installing Body Side Moldings-Wheel Opening Moldings
    G02655706Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals