LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Door - Front) >> Latch >> Removal

Section 63 (Door - Front): Latch: Removal

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove door trim panel. (Refer to BODY/DOOR-FRONT/TRIM PANEL-REMOVAL  )
  2. Peel back water dam as necessary.
  3. For access to latch, roll up glass and remove bolts attaching rearward glass run channel to door. Move and secure glass run channel.
  4. Remove screws attaching latch to door shut face (Figure ).
  5. Disconnect wire harness connector for power door locks, if equipped.
  6. Disconnect lock button to latch rod from the latch.
  7. Disconnect lock cylinder to latch rod from the latch (Figure ).
  8. Disconnect inside handle to latch rod from the latch.
  9. Disconnect outside handle to latch rod from the latch.
  10. Separate latch from door.