LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Overhaul - 46RE Automatic Transmission) >> Valve Body >> Assembly >> Governor Body, Sensor And Solenoid

Governor Body, Sensor And Solenoid

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn valve body assembly over so accumulator side of transfer plate is facing down.
  2. Install new O-rings on governor pressure solenoid and sensor.
  3. Lubricate solenoid and sensor O-rings with clean transmission fluid.
  4. Install governor pressure sensor in governor body.
  5. Install governor pressure solenoid in governor body. Push solenoid in until it snaps into place in body.
  6. Position governor body gasket on transfer plate.
  7. Install retainer plate on governor body and around solenoid. Be sure solenoid connector is positioned in retainer cutout.
  8. Align screw holes in governor body and transfer plate. Then install and tighten governor body screws to 4 N.m (35 in. lbs.) torque.
  9. Connect harness wires to governor pressure solenoid and governor pressure sensor.
  10. Install fluid filter and pan.
  11. Lower vehicle.
  12. Fill transmission with recommended fluid and road test vehicle to verify repair.
scientia non olet · About LEMON Manuals