LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Overhaul - 46RE Automatic Transmission) >> Output Shaft Rear Bearing >> Removal

Output Shaft Rear Bearing: Removal

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove overdrive unit from the vehicle. (Refer to OVERDRIVE UNIT  )
  2. Remove overdrive geartrain from housing.
  3. Remove snap-ring holding output shaft rear bearing into overdrive housing (Fig 1).
    Fig 1: Removing/Installing Output Shaft Rear Bearing
    G02658065Courtesy of DAIMLERCHRYSLER CORP.
  4. Using a suitable driver inserted through the rear end of housing, drive bearing from housing.
scientia non olet · About LEMON Manuals