LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Overhaul - 46RE Automatic Transmission) >> Bands >> Adjustments >> Adjustment-Bands >> Rear Band

Rear Band

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.

The transmission oil pan must be removed for access to the rear band adjusting screw.

  1. Raise vehicle.
  2. Remove transmission oil pan and drain fluid.
  3. Loosen band adjusting screw locknut 5-6 turns. Be sure adjusting screw turns freely in lever.
  4. Tighten adjusting screw to 8 N.m (72 in. lbs.) torque (Fig 1).
    Fig 1: Locating Rear Band Adjustment Screw
    G02658013Courtesy of DAIMLERCHRYSLER CORP.
  5. Back off adjusting screw 2 turns.
  6. Hold adjusting screw in place and tighten lock-nut to 34 N.m (25 ft. lbs.) torque.
  7. Position new gasket on oil pan and install pan on transmission. Tighten pan bolts to 13.6 N.m (125 in. lbs.) torque.
  8. Lower vehicle and refill transmission with Mopar® ATF +4, Automatic Transmission fluid.
scientia non olet · About LEMON Manuals