LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Overhaul - 46RE Automatic Transmission) >> Automatic Transmission-46RE >> Assembly >> Band Adjustment And Final

Band Adjustment And Final

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Adjust front and rear bands as follows:
    1. Loosen locknut on each band adjusting screw 4-5 turns.
    2. Tighten both adjusting screws to 8 N.m (72 in. lbs.).
    3. Back off front band adjusting screw 2-7/8 turns.
    4. Back off rear band adjusting screw 2 turns.
    5. Hold each adjusting screw in position and tighten locknut to 34 N.m (25 ft. lbs.) torque.
  2. Install magnet in oil pan. Magnet seats on small protrusion at corner of pan.
  3. Position new oil pan gasket on case and install oil pan. Tighten pan bolts to 17 N.m (13 ft. lbs.).
  4. Install throttle valve and shift selector levers on valve body manual lever shaft.
  5. Apply small quantity of dielectric grease to terminal pins of solenoid case connector and transmission range sensor.
  6. Fill transmission with recommended fluid. Refer to STANDARD PROCEDURE-TRANSMISSION FILL .
scientia non olet · About LEMON Manuals